cisco power over ethernet status external prime normal 15.4

SwTST01#show cdp neighbors gigabitEthernet 1/0/19 detail If i check the port with our 1532i that comes up whether i have 2x-mode enabled or not i get following: Power request id: 23382, Power management id: 2 Power request id: 23382, Power management id: 1 If i switch to the power inline port 2x-mode command, this is what i get: Power request id: 17641, Power management id: 2 Interface: GigabitEthernet1/0/20, Port ID (outgoing port): GigabitEthernet0Ĭisco AP Software, ap3g3-k9w8 Version: 8.3.111.0Ĭopyright (c) 2014-2015 by Cisco Systems, Inc. Platform: cisco AIR-AP1562I-E-K9, Capabilities: Router Trans-Bridge SwTST01#show cdp neighbors gigabitEthernet 1/0/20 detail Here the output with power inline static command: If anyone is interested: Īnother thing i checked is what PoE Power the AP is requestion via CDP. I ended up greating another post just to clarify the impact on these commands. As i like to have a default configuration for all ports my question is: Which configuration is recommended to use with these access points? And does this configuration then have an impact on other access point models (that drain 15 Watts only) or non PoE devices (like PC's or printers) that might cause problems? So basically i dont understand how a Cisco access point has trouble negotiating the correct amount of power to receive by a Cisco switch. SwTST01(config-if)#do show run int gi 1/0/20 Now it says it is draining 29.9 Watts on that port. So i deconfigured the static command and put this one in. There it says, i have to use power inline port 2x-mode on the interface to fix this issue. Gi1/0/20 static on 30.0 AIR-AP1562I-E-K9 4 30.0Īfter some more digging, i read about the Cisco Bug CSCsw18530 ( LINK) SwTST01(config-if)#power inline static max 30000 If i enable the following command, it comes online with 30 watts steady

Interface Admin Oper Power Device Class Max Show power inline shows a usage of only 15.4 Watts: %ILPOWER-3-CONTROLLER_PORT_ERR: Controller port error, Interface Gi1/0/20: Power Controller reports power Imax error detected It is constantly rebooting with following line in the log: We have a AP1562I-E-K9 that does not come online on a 2960X Switch.

Cisco power over ethernet status external prime normal 15.4